![]() ![]() An example of a table record is in Step 4. The MAC address is shown in the 'Physical Address' column with the IP address in the 'Internet Address' column. Since you have the MAC address, scroll down the list to find the associated IP address. Mar 9 20:47:03. This lists a number of MAC addresses with the associated IP addresses. Mar 9 20:47:02.311 SV: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/44, changed state to up To be able to see the WiFi MAC address, the WiFi radio has to be enabled, and there are 2 methods to find it: Open ISpyWifi. One is the WiFi MAC address, and the other one is the Bluetooth MAC address. Steps to determine the MAC Address of a remote system Open MS-DOS using CMD. Mar 9 20:46:54.594 SV: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/44, changed state to down There are 2 MAC addresses hard coded into the wireless chips of the mobile computer. Commands to find MAC Address: The 3 commands in discussion are stated below Command 1 ARP ARP is a Layer 3 protocol which is used by computers to resolve and track the TCP/IP and MAC address of the destination devices that you’re communicating to. Mar 9 20:46:53.580 SV: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/44, changed state to down Sw# show mac address-table | include gi1/0/10 Gi1/0/31ĭestination 1234.5678.9012 found on Switch_2Īlso, using the sw# terminal monitor command, you can check the logs shown in the CLI once you disconnect either the camera or the cable connected to the switch port (To know in which switch port is connected the camera). Sw# show mac address-table | include Gi1/0/10 Note: Remember that output modifiers are case-sensitive. Sw# show mac address-table | include Gi1/0/10 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |